Fixed bug in configuration.h

This commit is contained in:
Erik van der Zalm 2011-11-18 19:46:16 +01:00
parent e63e224a33
commit b15902d3b5

View file

@ -31,7 +31,7 @@
// Sanguinololu 1.2 and above = 62
// Ultimaker = 7,
// Teensylu = 8
#define MOTHERBOARD 5
#define MOTHERBOARD 7
//===========================================================================
//=============================Thermal Settings ============================
@ -176,10 +176,10 @@ const bool ENDSTOPS_INVERTING = true; // set to true to invert the logic of the
//#define INVERT_Z_DIR false // for Mendel set to false, for Orca set to true
//#define INVERT_E_DIR true // for direct drive extruder v9 set to true, for geared extruder set to false
//#define INVERT_X_DIR true // for Mendel set to false, for Orca set to true
//#define INVERT_Y_DIR false // for Mendel set to true, for Orca set to false
//#define INVERT_Z_DIR true // for Mendel set to false, for Orca set to true
//#define INVERT_E_DIR false // for direct drive extruder v9 set to true, for geared extruder set to false
#define INVERT_X_DIR true // for Mendel set to false, for Orca set to true
#define INVERT_Y_DIR false // for Mendel set to true, for Orca set to false
#define INVERT_Z_DIR true // for Mendel set to false, for Orca set to true
#define INVERT_E_DIR false // for direct drive extruder v9 set to true, for geared extruder set to false
//// ENDSTOP SETTINGS:
// Sets direction of endstops when homing; 1=MAX, -1=MIN
@ -242,11 +242,11 @@ const bool ENDSTOPS_INVERTING = true; // set to true to invert the logic of the
// The watchdog waits for the watchperiod in milliseconds whenever an M104 or M109 increases the target temperature
// this enables the watchdog interrupt.
//#define USE_WATCHDOG
#ifdef USE_WATCHDOG
//#ifdef USE_WATCHDOG
// you cannot reboot on a mega2560 due to a bug in he bootloader. Hence, you have to reset manually, and this is done hereby:
//#define RESET_MANUAL
//#define WATCHDOG_TIMEOUT 4 //seconds
//#endif
// extruder advance constant (s2/mm3)
//
@ -272,7 +272,7 @@ const bool ENDSTOPS_INVERTING = true; // set to true to invert the logic of the
//#define ULTRA_LCD //general lcd support, also 16x2
//#define SDSUPPORT // Enable SD Card Support in Hardware Console
//#define ULTIPANEL
#define ULTIPANEL
#ifdef ULTIPANEL
// #define NEWPANEL //enable this if you have a click-encoder panel
#define SDSUPPORT