0934563b97
Made the double touch portion a conditional compile based on the PROBE_DOUBLE_TOUCH flag. ============================================== Bugfix The current G38 only stopped a move if it involved the Z axis. Moved all the G38 code to it's own section and put it where it would always be executed no matter what axis was moving or if the endstop was enabled. Also added a comment to configuration_adv to alert the user the double tap had to be turned on. ============================================== Change G38 back to using Z_MIN_PROBE There's no Z_MIN endstop if Z_DUAL_ENDSTOPS is enabled and you have them set to the top of the gantry. G38 started out as using the Z_MIN_PROBE pin. I don't remember why we changed it to the Z_MIN endstop. |
||
|---|---|---|
| .. | ||
| DUAL | ||
| Configuration.h | ||
| Configuration_adv.h | ||
| README.md | ||
Felix 2.0/3.0 Configuration for Marlin Firmware
Bringing silky smooth prints to Felix.
Build HOWTO
- Install the latest non-beta Arduino software IDE/toolset: http://www.arduino.cc/en/Main/Software
- Download the Marlin firmware
- In both cases use the "Download Zip" button on the right.
cd Marlin/Marlin
cp example_configurations/Felix/Configuration_adv.h .
The next step depends on your setup:
Single Extruder Configuration
cp example_configurations/Felix/Configuration.h .
Dual Extruder Configuration
cp example_configurations/Felix/DUAL/Configuration.h Configuration.h
Compile Firmware
- Start the Arduino IDE.
- Select Tools -> Board -> Arduino Mega 2560
- Select the correct serial port in Tools -> Serial Port (usually /dev/ttyUSB0)
- Open Marlin.pde or .ino
- Click the Verify/Compile button
Flash Firmware
Connected directly via USB
- Click the Upload button. If all goes well the firmware is uploading
Remote update
Find the latest Arduino build:
ls -altr /tmp/
drwxr-xr-x 5 chrono users 12288 Mar 3 21:41 build6072035599686630843.tmp
Copy the firmware to your printer host:
scp /tmp/build6072035599686630843.tmp/Marlin.cpp.hex a.b.c.d:/tmp/
Connect to your printer host via ssh, stop Octoprint or any other service that may block your USB device and make sure you have avrdude installed, then run:
avrdude -C/etc/avrdude.conf -v -v -v -patmega2560 -cwiring -P/dev/ttyUSB0 \
-b115200 -D -Uflash:w:/tmp/Marlin.cpp.hex:i
Acknowledgements
Mashed together and tested on https://apollo.open-resource.org/mission:resources:picoprint based on collaborative teamwork of @andrewsil1 and @thinkyhead.