Aim: Test probes in update_endstops only when activated Changes: Configurations Add define for FIX_MOUNTED_PROBE to handle the situation where formerly ENDSTOPS_ONLY_FOR_HOMING had to be set, or lowering the nozzle below Z_PROBE_OFFSET_FROM_EXTRUDER could give an "endstop hit" message. Add define for Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN to indicate a common situation, that we have a probe but it is connected to an endstop pin Add some comments Shift some entries to have related things together. Conditionals.h We have a probe (HAS_Z_MIN_PROBE) if one of the pins is defined AND one of the probes is defined. SanityCheck.h Add some tests if the probe is connected and if we have defined a probe. stepper.cpp Changes to test the probe only when it is deployed (z_probe_is_active). Test update_endstops() when the probe is deployed. MarlinMain.cpp a. set and reset z_probe_is_active in deploy_z_probe(), stow_z_probe() and dock_sled() b. set and reset z_probe_is_active in the case a z-servo is moved to a defined position. The only remaining unhandled servo move is in M280 where we do not end in a defined position. If you want to handle a probe use M401/402 c. skip deploying/stowing when already deployed/stowed in the dedicated deploy/stow functions. d. Handle the new FIX_MOUNTED_PROBE in parallel to a servo driven probe/endstop. To do: In another PR. handle all probes in deploy/stow_z_probe. Sort out SERVO_LEVELING vs. HAS_SERVO_ENDSTOPS. |
||
---|---|---|
.. | ||
Configuration.h | ||
Configuration_adv.h | ||
Configuration_DUAL.h | ||
README.md |
Felix 2.0/3.0 Configuration for Marlin Firmware
Bringing silky smooth prints to Felix.
Build HOWTO
- Install the latest non-beta Arduino software IDE/toolset: http://www.arduino.cc/en/Main/Software
- Download the Marlin firmware
- In both cases use the "Download Zip" button on the right.
cd Marlin/Marlin
cp example_configurations/Felix/Configuration_adv.h .
The next step depends on your setup:
Single Extruder Configuration
cp example_configurations/Felix/Configuration.h .
Dual Extruder Configuration
cp example_configurations/Felix/Configuration_DUAL.h Configuration.h
Compile Firmware
- Start the Arduino IDE.
- Select Tools -> Board -> Arduino Mega 2560
- Select the correct serial port in Tools -> Serial Port (usually /dev/ttyUSB0)
- Open Marlin.pde or .ino
- Click the Verify/Compile button
Flash Firmware
Connected directly via USB
- Click the Upload button. If all goes well the firmware is uploading
Remote update
Find the latest Arduino build:
ls -altr /tmp/
drwxr-xr-x 5 chrono users 12288 Mar 3 21:41 build6072035599686630843.tmp
Copy the firmware to your printer host:
scp /tmp/build6072035599686630843.tmp/Marlin.cpp.hex a.b.c.d:/tmp/
Connect to your printer host via ssh, stop Octoprint or any other service that may block your USB device and make sure you have avrdude installed, then run:
avrdude -C/etc/avrdude.conf -v -v -v -patmega2560 -cwiring -P/dev/ttyUSB0 \
-b115200 -D -Uflash:w:/tmp/Marlin.cpp.hex:i
Acknowledgements
Mashed together and tested on https://apollo.open-resource.org/mission:resources:picoprint based on collaborative teamwork of @andrewsil1 and @thinkyhead.